Preps 5 punch mark

[JimG]

Need to remove or supress the punch center mark from the templates for 2 of our smaller presses. Press Operators say it is an issue (haha).

Any ideas??

[rhctp]

When you create the template you can put a measurment for Press Sheet edge to punch center. (In the second window after you name the template and pick the style) You can make this number 1" and it will pull the mark away from the template. I haven't had that problem before, but I am sure it will work.

[BigD]

Have you tried Preferences> general> display punch mark...

You can't use it on some plates and not on others - it seems to be all or nothing.

In the older versions of preps we had to edit a config file but the file is for preps not individual plate/press configurations.

If you put a Press Sheet edge to punch measurement in you will push the whole image up the plate, probably not what you want to happen.

We use it to create our correct grip measurements on our plates.

[JimG]

Took off the punch mark in the preference for all..(sigh)
I HATE small presses. :evil: