|
Media Height/Width Error
When I try to run film as an 11x17 I get an error message stating that my Media Height is longer than my Media Width. I have a Navigator RIP for an Agfa Accuset 1000 and am using Quark 5. I set up the page in QX several different layouts and changed the page layout setting in Navigator Page Setup several different ways. Nothing works. We recently purchased the RIP and I'm trying to set it up on my own - I've been very successful to this point. I can run 8.5x11 no problem. Any ideas or anyone experience a similar problem?
NOTE: I used to run a MArk 40 Linotronic with a NovaRIP. The page setup on that was 2" by 3" / Other. I also tried this - didn't work, but I always found that to be an odd page setting and never had trouble running film on it.
Matt
|
Linear Mode
