Forum

[C2C]

(( Not sure if this should go in here or Computer to Plate. Mods please move if this is incorrect. ))

Our platemaker is trying to plate a 6up layout and receives the following error: ( he has tried outputting them all and one at a time, same results )
being the Trendsetter spits the plate back out.

==============START============================
Created process for Signature 1 Surface A of imposition plan Planeta Info Aug 8, 2007 5:04:18 PM

Process Planeta.150lpi:Planeta:[1 Separation] submitted. Info Aug 8, 2007 5:04:18 PM

Created a new process with identifier 58583. Info Aug 8, 2007 5:04:18 PM

Job ticket submitted for processing. Info Aug 8, 2007 5:04:20 PM

Screening Information: Colorant: PANTONE 527 C, Screen System:

Creosettes, Dot Shape: Round-Square, Angle/Pattern: 45, Ruling/Feature Size: 150, Maxtone Highlight: 1, Maxtone Shadow: 1. Info Aug 8, 2007 5:04:28 PM

The Rip has reported the following: %%[ Error: limitcheck; OffendingCommand: image ]%%

Warning Aug 8, 2007 5:20:38 PM
An error occurred While RIPing the Task Error Aug 8, 2007 5:20:39 PM

Failed to Output PANTONE 527 C. Error Aug 8, 2007 5:20:40 PM

The Rip has reported the following: %%[ Flushing: rest of job (to end-of-file) will be ignored ]%%

Warning Aug 8, 2007 5:20:40 PM
An error occurred While RIPing the Task Error Aug 8, 2007 5:20:40 PM
The Rip has reported the following: %%[ Flushing: rest of job (to end-of-file) will be ignored ]%%

Warning Aug 8, 2007 5:20:40 PM
An error occurred While RIPing the Task Error Aug 8, 2007 5:20:46 PM
An error occurred While RIPing the Task Error Aug 8, 2007 5:20:48 PM

Output has finished. It was queued for 0.8 seconds and active for 983.7 seconds. Info Aug 8, 2007 5:20:49 PM

Job ticket: processing has completed. Info Aug 8, 2007 5:20:49 PM

=====================END========================

The layout was created using Pandora v2.8.0 (build 515)

I can only recall one other time we had the Trendsetter 800 II Quantium
not plate a layout and it was with an 18 up Cig pack layout. I was not there to see how it was resolved and the person who was is on Holidays for another 4 days.

The file within the layout is a De-screened DCS file, 4 colours (3 spots and Black)
Placed in Quark 6.5 and output to a Postscript.
.
Run through Workshop and Virtual Proofed .
All looks and Seps fine.
(no major errors when refined)

I have re done a layout and received the same results when trying to plate this job.

Perhaps creating an entirely new job folder and re running the file through workshop again ?

Any Ideas ??

Thanks

C2C