|
Flexo question Rampage and Preps
Is there anyone ot there using Rampage with Flexo work, and if so (I imagine there are)
How does your work flow work, We currently make the 1up label in illustrator or Quark or Indesign, then in either a seoerate page or document, draw off bearer bars, and step and repeat the label, and distort, according to our charts for distortion.
We rip a single eps of the 1up label for proofing to customer, and we also rip the imposed miltiple up version for the film
We are trying to figure out if Preps might be able to be helpful, rather than keep setting up all of these damn bearer bars, for each job. OVER AND OVER AND OVER.. Get my drift....
I thought that I remembered seeing some info on this somewhere, but wasn't sure where...
__________________
Digital - Flexographic - Offset
Rampage 9.4
Epson 10600
G5 w/OSX - WINxp(when forced)
Adobe CS3 - Quark 6.5
|
